Symmons S-8102-RP Installation Guide download pdf (Page 3)

Page 3

2) Attach escutcheon

3) Attach dome cover

4) Attach handle

5) Attach showerhead

6) Attach tub spout

1) Attach escutcheon

mounting plate

factory

installed

gasket

1/8"

Installation

optional

7) Flush system, check for leaks

■ Turn valve to the warm position

and run for a few minutes.

■ If system is dirty, remove valve

spindle in center of valve to

ensure proper ushing. (See

service instructions.)

■ Check for leaks around valve

assembly and all pipe ttings.

8) Set Temp Limit stop screw

Reference page 2, gure 3

e temperature limit stop screw

limits valve handle from being

turned to maximum position

resulting in excessive hot water

discharge temperatures.

Warning: Failure to

adjust Temp Limit stop

screw properly may result

in serious scalding.

■ Place handle on control spindle

stem and open valve to maximum

desired temperature.

■ Turn Temp Limit stop screw

clockwise until it seats.

Note:

Do not install positive shut-

o devices on control valve outlet or

devices that do not allow the valve to

ow at least 1.5 gpm.

Tub

Shower

Clean nished area using mild

soap and water or a non-abrasive

cleaner and then quickly rinse. A

non-abrasive wax may be used to

preserve nish area.

Care and Cleaning

Diverter Control Handle

Operation

Trim Installation

1 2 3 4 5 6 7 8 ... 11 12

Comments to this Manuals

No comments